Product Overview
Enjoy a warm welcome home with the Rinnai Ember, the little hottie that offers a stunning glow of a wood fire, the superior warmth of a gas fire, and none of the hard work!
A small gas fire with compact dimensions suitable for new builds and renovations. The Rinnai Ember is available in two sizes and delivers over 5 kW of heat output.
With stunning burn media options, large viewable flame area, and frame choices to suit your lifestyle.
Temperature control
Back-to-basics simple infra-red remote makes operation easy and stress free, or upgrade to Wi-Fi capability with our Wi-Fi module retrofit kit, part number R7000 (RRP $264 plus installation). This will need to be fitted by a licensed gasfitter.
Available for Natural Gas or LPG, specify at the time of purchase
120 V AC 50 Hz 2-speed centrifugal blower. Heat is distributed from the top of the appliance.
Located on the lower RHS of the base panel, in front of the gas control.
Brass ½ ” BSPT male fitting. The gas supply terminates inside the heater, lower RHS of the appliance.
230-240 V AC 50 HZ high voltage electronic spark generation unit.
37-45 dB(A)
Colinear flexi flue, air intake Ø 75 mm, exhaust Ø 100 mm. Appliance must be installed with a Rinnai Ember flue system.
Refer below comment regarding the DV high wind vertical cowl protection kit.
Colinear (air intake Ø75 mm, exhaust Ø100 mm) to coaxial direct vent flueing (inner Ø100 mm, outer Ø170 mm). Appliance must be installed with a Rinnai Ember flue system.
N.B: For windy areas such as Wellington, coastal properties, and elevated properties on hills we recommend an additional flue component call the DV high wind vertical cowl protection kit (R3655). It is designed to wrap around the flue cowl to reduce wind entering the flue and causing flame disturbances. Refer to the installation instructions in the ‘Downloads’ tab for more information.
- High 110 W
- Standby < 1 W
The Ember has a 1.5 m power cord with a 3-pin plug supplied. The power cord passes through a slot in the back right hand corner of the appliance.
Flame failure sensing system, pressure relief, overheat safety switch, air temperature sensor, thermal fuse, overcurrent fuse, and spark detector.
Operated using a basic infra-red remote, or for more features such as timers and thermostatic control, by using a Wi-Fi module (purchased separately) and using the Rinnai Wi-Fi fireplace controller app.
- Ember 600 – 51 kg
- Ember 700 – 55 kg
The minimum clearances listed below are measured from the edge of the outer glass.
- Above – 400 mm
- Sides – 400 mm (includes side walls)
- In front – 1000 mm
These are the unit dimensions only, not the framing/cavity dimensions
- Ember 600: A-640 mm, B-644 mm, C-618 mm, D-580 mm
- Ember 700: A-740 mm, B-644 mm, C-618 mm, D-680 mm
